Buy Thermo King T-Series Refrigeration Units Online

Buy Thermo King T-Series Refrigeration Units Online

T-Series (Stage V compliant)

Delivering what matters

Thermo King’s new T-Series is the result of years of research and exhaustive testing. The T-Series sets new industry standards for reliability, performance, efficiency and low cost of ownership. The T-Series delivers greater capacities at lower operating speeds and allows for precise temperature control. Low operation and maintenance costs, as well as fuel saving technologies, keep cost of ownership to a minimum.

The best solution available for CNG Rear Mount applications.

When Thermo King established performance criteria for the T-Series, high ambient capability was a “must have”. Extensive field trials and thousands of running hours have proven the design able to perform in even the harshest of conditions, right up to 55°C. A heating option has been especially developed to ensure top performance at low ambients too.

Operation is easy and error-free, thanks to new, intuitive in-cab controllers. Ease of monitoring means the units will deliver optimum performance with maximum efficiency. The T-Series minimises an operator’s carbon footprint with reduced exhaust emissions and less waste. Whisper quiet operation will allow access to noise sensitive urban delivery areas.

With the widest range in the truck refrigeration industry, there is a model to suit all trucks from the smallest to the largest, running one, two or three temperature zones.

Thermo King NEW T Series

Thermo King has an all-new T-Series of temperature control units for straight trucks

The T-Series will be built at Thermo King plants in the United States, Ireland, and China. The new series eventually will replace all of the truck refrigeration units in Thermo King’s current lineup.

Thermo King has made major improvements with the T-SeriesThe plastic exterior skin is durable; engine and compressor are more efficient; and our hybrid SmartPower option can reduce fuel consumption and engine emissions by 40% to 60%. Noise is reduced by up to 87% with the hybrid option.”

The T-Series was developed to provide improved performance and a lower lifecycle cost. Highlights of the new units, which have the latest state-of-the-art features and a sleek new design that allows for easy access for service, include:

• A new TSR-2 controller with durable LED technology that helps ensure the correct parameters are set for every load, regardless of the language spoken by the driver.
• A choice of the time-tested reciprocating compressor or the new scroll compressor which has added technology for improved reliability, higher capacity, and greater fuel efficiency.
• Stationary or the optional over-the-road Hybrid SmartPower electric operation for fuel savings and zero emissions. The hybrid option is intended primarily for use
• Enhanced Whisper technology for “the quietest Thermo King truck units ever.”

The T-Series is backed by the strongest warranty the company has ever offered.

Units available include the T-500R, T-600R, T-800R, and T-1000R with reciprocating compressors; T-600, T-800, T-1000, and T-800 Spectrum multi-temperature; and T-1000 Spectrum multi-temperature with new scroll compressor technology.

Thermo King offers system diversity to fit your individual requirements.

The T-Series was developed to provide customers with improved performance, new state-of-the-art features and a lower life cycle cost that makes a real difference on the bottom line. Thermo King customers are the driving force behind the ongoing innovation that led to the T-Series,

so it was only natural that their input played a key role in the development of these new units. Time and time again, customers asked for cost and fuel savings, improved reliability and performance, quieter, cleaner operation, and that they are easier to use and service. Thermo King listened, and the result is the T-Series.

Here are just a couple examples of what’s new and improved:

• The new T-Series symbolic interface with SR-2 controller features durable LED technology and helps to ensure the correct parameters are set for every load, regardless of the language spoken by the driver
• Customers can choose between the time-tested reciprocating compressor or the new scroll compressor, which boasts added technology for improved reliability, higher capacity and greater fuel efficiency

Units available include the T-500R, T-600R, T-800R and T-1000R with reciprocating compressors and the T-600, T-800, T-1000, T-800 SPECTRUM multi-temperature and T-1000 SPECTRUM multi-temperature with new scroll compressor technology.

T-Series Heating Option

For extreme cold environments

When delivering temperature sensitive cargo under extreme low ambient conditions, operators demand a reliable, durable refrigeration unit which will give maximum up-time while fully protecting their valuable cargo. In other words, complete peace of mind.

Customers in extreme low ambient conditions need refrigeration units with sufficient heating capacity to maintain loads in their optimum condition. To meet these special requirements, Thermo King has developed a means of capturing heat from the unit’s engine coolant and using it to boost heating performance. A secondary coil is built into the evaporator through which the coolant is routed to give heating capacities which are up to double the conventional values.

With the T-Series Heating Option

• T-600R and T-800R heating capacity on engine power is more than doubled to 6220W using water heat kit
• T-1000R is increased by 46% to 6000W with heat upgrade
• No additional refrigerant charge is needed for any of the above so there is no environmental impact
• Electric heater bars option gives an additional 1900W for all units on electric stand-by

Unmatched versatility to meet customer specifications.
 Refrigerant Options
• R134a
• R407C

 Motor Options
• Brushless
• Wound Field
• Permanent Magnet

 Compressor Options
• X426/X430
• S391 Screw
• S616 Screw

Evaporator Airflow* *
0 mm (0 in.) water column external static pressure High speed fan -3814 m3 /hr (2250 cfm) Low speed fan -2366 m3 /hr (1400 cfm)
* *Consult factory for optional airflow on high speed or low speed fan operation.

Performance Data
System net cooling capacity with 35°C (95°F) ambient, and 26.7°C (80°F) db, 19.5°C (67°F) wb evaporator return air (50% RH):

System Heating Capacity
24,696 KCal/hr (98,000 Btu/hr)@ 8 GPM & 160°F water

Electric Power Requirements
AT 27V dc
High speed fan: 106 amps (high speed evaporator and condenser fans) Power source: Bus alternator or Thermo King batteryless alternator (options below)

T-Series Standard Features
Why pay for more than you want. Thermo King provides standard features designed to meet your needs.

Thermo King’s IntelligAIRE III Control System Delivers Industry-Leading Capability with Unmatched Ease-of-Use

High Performance R-407C
• Environmentally safe alternative that provides more BTUs of cooling per HP used
R-134a Refrigerant
• Environmentally-friendly solution
The Thermo King X430 Compressor
• Engineered exclusively for transport applications
• Built for extended service life
• Field repairable

– Multiple zones can be controlled using identical expansion modules via CAN network and interconnected software
– Expanded CAN communication capability to plug directly into the vehicle’s J1939 network
– Operator-friendly display and pressure modules for improved control and diagnostics

Additional Standard Features

Evaporator fan motor
– Heavy-duty, double shafted industrial permanent magnetic motor with replaceable bearings and brushes
– 27V, 1.15 hp, 1700 rpm (high speed)
– Drives two large, high airflow, forward curved, centrifugal blowers Condenser fan motors
– Two, heavy-duty, industrial permanent magnet motors with replaceable bearings and brushes
– 27V, .75 hp, 1900 rpm (high speed)
– Each motor drives a 457 mm (18 in.) diameter axial flow fan

Four simple modules remove complexity for operators and technicians.
Display Module    –   Pressure Display Module     –     Main Module      –     IO Module

Unit Operation W/Driver Mode Switch
Reheat: Compressor clutch continuously engaged, boost pump and water control valve cycling is controlled by thermostat.
Cool: Compressor clutch cycles On/Off on demand of thermostat.
Vent: Evaporator fan operation only.
Heat: Boost pump and water control valve cycle on demand of thermostat. Compressor clutch off.

Introducing the T-Series
Lowest fuel consumption
• Through extensive development and field experience, Thermo King has found the right balance between system efficiency, fuel consumption and performance in all ambient conditions for both fresh and frozen produce
• Advanced technology such as the Truck Smart Reefer (TSR-3) controller and micro-channel condenser coils means greater fuel efficiency
• On the T-1200R and T-1200R Spectrum, an Electronic Throttling Valve (ETV) reduces engine emissions and increases fuel economy
• Faster pull-down means lower fuel consumption during pre-trip runs and in between door openings. Lower life cycle costs
• The TSR and TSR-3 controllers allow optimum system management to give maximum protection at minimum operating cost for every type of load
• Extended Maintenance Interval (EMI) increases time between service intervals up to 2000 hours. This reduces
maintenance, clean-up and disposal costs while extending engine life with highly efficient oil filtration
• All T-Series units come with a full two year warranty

Easy to use
• The intuitive TSR-3 controller features a symbolic display for error-proof operation
• Critical information is clearly displayed
• Service interval and scheduled maintenance reminders can be pre-programmed

Easy to service
• New external panel design allows improved service access to electrical and engine components
• ServiceWatch™ records system operation to reduce diagnostic time.

Reduced environmental impact
• All the T-Series range features GreenTech™ engines which are the cleanest on the market, exceeding all existing EU
requirements for emissions control
• Micro channel condenser and radiator coil means up to 33% less refrigerant charge compared to old models and reduced environmental impact
• Extended Maintenance Intervals reduce oil, filter and coolant waste
• High gloss impact-resistant external panels mean 99.7% of the unit (by weight) is recyclable
• The T-Series range is manufactured at Thermo King’s state-of-the-art facility in Galway, Ireland, which has held ISO
14001 certification for Environmental Management since 2000, and ISO 50001 certification for Energy Management
Systems since 2012.

Up to 60% quieter operation
• T-Series Whisper™ technology dramatically reduces operating noise to permit access to noise sensitive areas
• Components including poly-V stretch belts with Quiet Channel technology and quiet fans reduce noise generation
• Super-absorbent foam reduces noise transmission

The toughest Range in the industry
• An extensive range of single and multi temperature units means there is a model to suit all trucks, from the smallest to the largest
• There is a spread of cooling capacities to meet the most demanding applications:
• 6200 to 12500 Watts at 0°C
• 3400 to 6800 Watts at -20°C
• All models have been proven to perform right up to 55°C, the highest benchmark in the industry

The GreenTechTM engine from Thermo King Lowest emissions, highest performance

All the T-Series truck refrigeration units are fitted with GreenTech engines from Thermo King. These engines drastically reduce emissions, waste and noise pollution, exceeding the most stringent EU standards (NRMM: Stage V compliant).

GreenTech engines are the cleanest engines on the refrigeration unit market. Performance has been enhanced too; more power means less component stress and longer life.

Engine life
The new engines run at no more than 80% of their maximum output. Thus, both oil and coolant temperatures are reduced, resulting in less component stress and less wear and tear on the engine.

Bio-fuel compatibility
All the new engines are approved for use with B7 fuel (7% bio/93% petroleum diesel) with no change in maintenance
schedules. Fuels with higher bio-diesel content (B8 up to B100) require shorter intervals between oil changes and injector servicing. Thermo King Dealers can provide more information.

The new TSR and TSR-3 controllers Most advanced, but easiest to use

Powerful and simple to use, the new TSR and TSR-3 T-Series controllers make it easy for drivers to accurately manage the temperature in the truck, no matter what the load being hauled. Step-by-step instructions, depicted in symbolic form, make it quick and easy to precisely set and adjust the refrigeration unit, helping your customers, your drivers and your business.

TSR and TSR-3 Standard in-cab display   |   TSR-3 Premium in-cab display

Lowest emissions
Highest performance
The GreenTechTM engine from Thermo King Lowest emissions, highest performance The new TSR and TSR-3 controllers Most advanced, but easiest to use With the new Thermo King GreenTech engines, emissions of particulate matter (PM) have been substantially reduced.

Improved diagnostics
The TSR controller includes the new Remote Watch service feature: a user-friendly web-based interface enabling on-the-road service and diagnosis, minimising truck downtime and reducing labour costs. The ServiceWatch™ service logger is integrated in the TSR-3 controller and provided as standard.
• Enables faster and more accurate fault diagnosis
• Reduces downtime and labour hours
• Keeps a record of system operating modes and
performance characteristics

Easy-to-read display
The new LED display is bright and clear, ensuring better visibility in all light conditions and at all ambient temperatures.

Enhanced safety and security
At the end of the day, protecting the load is what matters. The TSR and TSR-3 controllers make that job easier and even more effective with a range of enhanced features:
• Keypad with lock-out to avoid tampering
• Phase correction to avoid reverse fan rotation on electric standby
• Diesel/electric auto switching to protect cargo in the event of electrical power outage
• Set point warning to protect the load
• Oil and coolant level alerts to protect the engine
• Tiered security access levels for appropriate personnel to simplify operation and avoid operator error
• Diesel engine and electric stand-by hour meter display
• Data Acquisition System (DAS) and TracKing
compatibility (Not available on T-560R)
• Password protection

New intuitive interface
Drivers will find the new TSR (available on T-560R only) and TSR-3 Standard in-cab display easy to use and fully intuitive. Critical information is clearly displayed using LEDs which are unaffected by high cab temperatures. Numbers and symbols avoid the use of language and keep things simple. Buttons with illuminated symbols avoid the use of menus to select key functions including Cycle Sentry, high speed inhibit, defrost and pre-trip check.

Set point changes are error-proof with colour coded up/down keys, set point temperature display and an enter key to confirm. For even greater control of every aspect of a T-Series unit, a graphic TSR-3 Premium in-cab display is available as an option. The simple and logical menus, easy to read screen and choice of 21 languages make this the interface of choice for the advanced operator.

Fuel savings
The TSR and TSR-3 controllers include advanced features that deliver even greater fuel savings including:
• Cycle-Sentry™ mode
• ETV (T-1200R and T-1200R Spectrum only)
• Electronic door switch input